What are run-flat tyres and can any fitter work on them? +
Run-flat tyres have reinforced sidewalls that support the weight of the car even with no air pressure, allowing you to drive up to 50 miles at 30mph after a puncture. They require specialist fitting equipment and a TPMS reset after replacement. Not all garages can work on run-flat tyres, but most professional mobile fitters and tyre centres are fully equipped. Run-flat tyres are typically 20–40% more expensive than standard equivalents.
Are part-worn tyres safe to buy? +
Part-worn tyres carry significant risks. While they are legal to sell in the UK, studies have found that a large proportion fail to meet legal standards — many have been previously repaired improperly, have internal damage not visible from the outside, or are close to the legal tread limit. The small saving is rarely worth the risk. New budget tyres from reputable brands often cost only £15–£25 more and come with a full warranty.
How long does it take to fit a new tyre? +
A single tyre change typically takes 15 to 30 minutes, including removing the old tyre, fitting and balancing the new one, and torquing the wheel nuts to the correct specification. If you are having all four tyres replaced, expect the job to take around 45 minutes to an hour. Mobile fitters work to the same timescales as a garage.
Is it safe to drive on a slow puncture to reach a tyre fitter? +
If the tyre is only slightly low and you can maintain safe control of the vehicle, you can drive a short distance at reduced speed — no more than a few miles at 20–30mph. Check the tyre regularly as you drive. If the tyre is visibly flat, the sidewall is bulging, or the car feels unstable, do not drive at all. Call a mobile tyre fitter to come to your location instead.
Do I need to replace all four tyres at the same time? +
No, you do not need to replace all four tyres at once unless they are all worn. It is best practice to replace tyres in pairs (both fronts or both rears) to maintain even handling. The newer tyres should always go on the rear axle for stability, even on front-wheel-drive cars. Mixing tyre brands on the same axle is not recommended but is acceptable across different axles.
What should I do if I get a flat tyre on the motorway? +
Pull onto the hard shoulder as far left as possible, switch on your hazard lights, and exit the vehicle from the passenger side away from traffic. Do not attempt to change a tyre on the motorway hard shoulder — it is extremely dangerous. Move behind the crash barrier if there is one, then call a mobile tyre fitter or breakdown service. If you are on a smart motorway with no hard shoulder, stop in an emergency refuge area.